How To Effectively Control The Glue Output Of The Dispenser?

Glue dispensing machine, also known as glue applicator, glue dispenser, glue machine, glue pouring machine, etc., specializes in controlling fluid. And the automatic machine that drips and coats the fluid on the surface of the product or inside the product can realize three-dimensional and four-dimensional path dispensing, precise positioning, precise glue control, no wire drawing, no glue leakage, and no glue dripping. The glue dispenser is mainly used for accurate pointing, injecting, coating, and dripping of glue, paint and other liquids in the product process to the precise position of each product, and can be used to achieve dots, lines, circles or arcs.
The glue output operation of automatic glue dispensing machine and glue filling machine is a constant research proposition in every packaging industry. The size of the amount of glue and the time of glue out have a great influence on the quality of the packaged product.
Automatic glue dispensing machines and glue filling machines use pistons to operate glue volume. The size and flow of glue are determined by the trajectory of the piston in the rubber cylinder. The piston realizes displacement in the rubber cylinder, and the rubber output will also change relatively.
When operating the dispensing machine and the glue filling machine to set the glue output during the operation, the intention is to accurately operate the glue output, and this goal can be achieved through accurate calculation and calculation. Packaging manufacturers always use an electronic ruler to measure the trajectory of the piston, and then convert the actual colloid volume and colloid ratio of the proof through the correct conversion of the system principle, and finally obtain the size of the colloid amount.
For some requirements of automatic dispensing machines and glue filling machines, it is necessary to set each specific quantity through the system, that is, implicitly set the travel interval and travel trajectory of the piston. When the fluid in the hose is activated, with the skill of operation, the assimilation tube and other required fluids can then be synchronized. Therefore, the density of the glue, the size of the glue and the outflow rate are accurately positioned, and finally the purpose of accurately operating the amount of glue can be achieved.