How To Change The Glue Type During The Packaging Process Of The Automatic Glue Dispenser?

During the packaging operation of the dispenser, replacing the glue is an extremely critical link, taking into account the setting and maintenance and the service life of the setting. The following will answer how to replace the glue during the packaging process of the automatic dispenser.
In the packaging process of the glue dispenser, in view of the particularity of packaging requirements, more than one glue is often needed to achieve product packaging and bonding. Therefore, during the packaging process, it is often necessary to replace the hose. The replacement of the hose is very important to the packaging quality of the product and the later recovery of the packaging setting.
Before the automatic dispensing machine cylinder, the automatic dispensing machine needs to deal with the residual glue in the early packaging process and clean the rubber pipes. Before cleaning, close the feed valve to avoid glue mixing and increase the difficulty of cleaning. After cleaning, open the rubber discharge valve, pour out the residual rubber in the rubber cylinder, and then close the rubber discharge valve. Then open the feed valve, pour the cleaning solvent specially used for rubber cleaning into the pressure barrel for storing rubber according to the cleaning needs, and activate the machine. The solvent is pressed out according to the usual control method, and then cleaned. The cleaning process of the rubber cylinder has been basically completed, and then the next rubber that needs to be ordered is put into the rubber cylinder.